Analog Waveguide - Firmware Updater

WebUSB DFU flashing tool. Runs entirely in the browser.

1 · Check Installed Version

No live firmware-version check is performed — confirm you're flashing the right release before starting.
  1. Press the factory settings button (on the right side of the bottom board, next to the USB-C port) momentarily.
  2. Use the Rotation knob to navigate to the “Show firmware version” menu entry and press the factory settings button to enter.
  3. The display now shows the currently installed firmware version along with its build date.
  4. Press the factory settings button again to go back.

2 · Put the module in DFU mode

  1. To enter the menu, press the factory settings button momentarily.
  2. Use the Rotation knob to navigate to the “Firmware update mode” menu entry and press the factory settings button to enter.
  3. Press and hold the firmware update button for two seconds to put the module into firmware update mode.
  4. You are now in firmware update mode. The module will stay unresponsive until the update is complete. If you'd like to cancel the update before the flashing process is initiated, just powercycle the module.
  5. Connect the Analog Waveguide to your computer with a USB-C data cable.

3 · Firmware source

Please select a firmware version from the list below.
…or upload a .bin file

4 · Device

not connected

5 · Update

Your personal settings and calibration parameters will persist after the update. You can safely update. In the unlikely case that something went wrong, please consult section 7.3 Troubleshooting in the user manual.
Ready.